- #Dd wrt v24 sp2 repeater setup how to
- #Dd wrt v24 sp2 repeater setup full
- #Dd wrt v24 sp2 repeater setup mac
If the PPPoE connection ever is available again, the router should switch back to it once it detects that the connection is available.Ĭan all this be done with a single DD-WRT micro running on a Linksys WRT54G2 v1.0? What are the VLANs needed, what bridges should I create? The two connections should work as follows: the faster (PPPoE) one is the "default", every computer should use that connection unless it is down (this may be detected by pinging the gateway, or by any other means if anyone has a better idea), in which case the router should automatically switch to the slower (DHCP) connection. Internet connectivity (dual WAN with failover):įinally, I have 2 internet connections: a fast one through PPPoE and another, slower on, to which I must connect with DHCP (to obtain a public IP address from the ISP through the cable modem).Īll the networks (LAN, internal WLAN and guest WLAN) must be able to access the Internet.
The guest WLAN cannot see the LAN, nor the other WLAN (the internal one).Īll the computers connected to any of these networks (LAN, internal WLAN and guest WLAN) should be able to obtain IP addresses and DNS server addresses from a DHCP server on the router. The internal one should be completely connected to the LAN (that is, all boxes on the wired network and the internal wireless network must see each other). I want to have 2 WLANs, one internal and another for guests. I want to set up one wired LAN (maybe someday I will partition this into two and connect them with another router, maybe this information could change the way to configure the WRT54G2 now, I don't know). DD-WRT v24-sp2 (10/10/09) mega (SVN revision 13064) and it still shows unnamed network in the wireless survey. I have some knowledge on Linux networking and routing, but nothing too fancy.
#Dd wrt v24 sp2 repeater setup full
(Click on a picture to view its full size.) System Info.
#Dd wrt v24 sp2 repeater setup how to
I've studied the documentation (notably, which describes the router's ports), but I can't figure out by myself how to achieve what I want. Some screenshots have small distortions that were used to blur out personal info such as IP addresses and usernames. Silence repeating messages mute 20- END OF. I followed instructions for the webGUI server setup and the Tunnelblick-specific client setup, but.
#Dd wrt v24 sp2 repeater setup mac
but I cannot get my mac connect to the OpenVPN server. I've installed DD-WRT v24-SP2 micro on a Linksys WRT54G2 v1.0, and I'd appreciate some help on setting up a not-so-trivial network. troubleshooting server DD-WRT v24-sp2 (06/08/12) big - build 19342 and client Tunnelblick 3.3beta32 (build 3183) - OpenVPN 2.3-alpha1.
0 kommentar(er)
